Denefrips Pontus "burn in" period?


Hello all

 

Now there's a chance I may be a little premature with this, but I've received my Pontus 8 days ago and have had it running ever since, powered up, most of the time with signal going through it, and so far I'm a little concerned. I am aware that with this particular dac it is recommended to run it roughly 10 days before it really burns in, but being only a couple of days away, I can't say the sound has changed very noticeably. Matter of fact, when I A/B with my project S2 plus dac, and even my blue sound node internal deck, I can barely tell a difference! Does burning happen gradually? Is there all of a sudden a hallelujah moment where this thing starts kicking ass? Does anybody have more experience with this particular piece of gear? Current system is rogue audio ST100 amp, rogadio RP1 preamp, upgraded tubes, blue jean cabling, upgraded power cords on power amp and preamp. I had high hopes that this dac that has received so much high praise was going to blow my meager dacs out of the water, and so far not the case at all. I must say, the thing weighs a ton and looks gorgeous, but I'm getting a little concerned at this point that I may end up disappointed. Talk me off the ledge!

 

128x128jin78

@jjss49 wow! So I guess I should try out the other outputs on the node! Was this confirmed for the latest node?

I'm using a older BS Node2 connected to a fully broken in Pontus ll with coax and I'm getting outstanding results. While I haven't tried different streamers, the SQ with coax is still very good. I have a decent turntable setup and while it sounds a bit better than the streamer/dac combination, it doesn't embarrass them either.

 
see below... his reply to my inquiry about my pontus not playing hi res (above redbook) streamed content from qobuz and tidal via node/node 2i
 
For hi-res, Node2i and Pontus Coax may not be compatible due to lower output VPP on the Node2i Coax output.
 
At hi-res, the data rate is much faster, hence, the signal may not be able to decode by the Pontus DAC. Would you please try the OPT connection instead?.

 

Many thanks.

Yours sincerely,

Alvin Chee

VINSHINE AUDIO PTE. LTD. (SINGAPORE)

Let it burn in for 200 hours then decide.  I’ve noticed big changes at 100 hours and incremental improvements after that up to 200 hours.  Give it a chance.  Ignore those who say there is no break-in time on electronics.

@jjss49 DUDE. You nailed it! I switched out the coax for a crappy USB cable  I had laying around, from the node straight to the dac and BOOM...deeper soundstage, more defined,  more balanced chill sound...whoa. 

Remember I said I was switching back and forth from my analog rig to the new dac, and my analog sounded a lot sweeter. Wasn't even close. Now it's close! Song for my father by Horace silver sounded way better on vinyl before, now it's pretty darn close. What the hell! Still have to play around with the optical....