100 dBs SPL is painfully loud. I never listen to those levels as well. The video is just a demonstration and it lasts no more than a minute. The room is 34 square meters and the microphone is placed at 2m distance from each speaker.
Paul Klipsch was right - What the world needs is a good 5 watt amplifier
For those who are questioning whether a low power high quality amp would be able to properly drive any speakers I've recorded a short video demonstrating very high SPL level from a speakers with average sensitivity. The video is of very low audio and video quality as its recorded from my smartphone. However, the microphone used for measuring the sound pressure is MiniDSP UMIK-1 and the software used is REW (Room EQ Wizard). During the tests the amplifier didn't show any hint of stress of distortion
The speakers used in this video are Sonus Faber Olympica II and the integrated amplifier is Pass Labs INT-25. According to some third party reviews the Olympica's are thought load for the partnering amplifier as their sensitivity is averagely rated (88db) and the impedance curve drops down to 3 ohms in the bass region with a estimated EPDR (the point where the impedance curve is intersecting with the phase angle) of 1.6 ohms. The pass labs is rated at 25wpc @ 8omh and is said to be stable down to 1 ohm doubling its power at 4 and 2 ohms. According to the manual it can deliver 200wpc @ 1ohm before the protection circuit is activated.
So, the point of the video is to show that the Pass with its poorly rated power (25wpc) can drive even demanding speakers to insanely loud levels without any sound degradation.
- ...
- 49 posts total
@divertiti Ignored. |
Sure they do- but for that simple reason you rarely see them , and I've found that many people don't understand what the measurements are saying. The things to look at are distortion vs frequency (must not rise across the band or the equipment will sound bright), distortion spectra at 1 watt and at all frequencies, distortion spectra at -6dB of full power, and IMD (not CCIR version), the latter at -6dB of full power. Interpreting this information properly will tell you exactly how the amplifier will sound.
If this is the case it points to a distortion problem causing the pain, unless you have hyperacusis. |
- 49 posts total