Top linear trackers

If you have the bucks check out the CS Port from Japan. 

This will not even register in your search radar, but as someone has mentioned the Trans-Fi Terminator should be on your list. 

Look at the manifold, an inverted ‘v’ as opposed to a circular tube in most other cases. It is an inherently more stable ( no tendency to roll ) platform for the cartridge / wand assembly to glide on. It is low pressure / high flow operating as low as 0.5 psi ( I run it at 1.25 psi ), which can easily accommodate surge tanks for elevated SQ and aquarium type compressors are more than adequate. And the value proposition is out of this world.

Please review discussion of this arm on another thread : 2019 update Trans - Fi Terminator. You will find users of other ‘higher caliber ‘ arms, LT or otherwise, moving to the Terminator. Most recently a Clearaudio TT5 user taking up the Terminator, resulting in the purchase of a second Terminator to boot!

While I use a linear tracking arm, I do not subscribe to the notion that one technology is superior to the other. It is in the implementation / execution. However, to find a matching pivot arm at Terminator’s price range is impossible.

@ledoux1238 I am aware of the Terminator and read a number of threads on it. Anyway, may I ask you: In your experience does the Terminator function better with lighter / higher compliance carts or the opposite?

@solypsa I am using a ZYX Ultimate Omega ( medium compliance, 12 ) and Audio Tekne MC-6310 ( med / high compliance, 20 ). These work very well with the Terminator.  My own experience has been limited to various  medium / high compliance cartridges. 

On a seperate thread, @terry9 reported that Koetsu RSP, 12g and low compliance, did not work with Terminator's aluminum arm wand. He then developed a heavier Panzerholz wand which then worked very well. And Someone is using a Clearaudio GFS, 16g, though med compliance. Due to Terry's experience, I have held off on venturing into low compliance territory. While I feel that the newer carbon fiber wand which I use should work with Koetsu's, I would think twice about putting a stone body Koetsu. 

Look at the manifold, an inverted ‘v’ as opposed to a circular tube in most other cases. It is an inherently more stable ( no tendency to roll ) platform for the cartridge / wand assembly to glide on.

Actually thats misleading. Although it uses parallel V extrusions which tend not to roll laterally, the Terminator uses a floating air bearing. If I hooked up a high pressure pump I could blow the arm off its rail. If there are any deviations in air flow this arm will bounce along the rail.

The Eminent Technology uses a far superior captured air bearing - the spindle runs through a manifold and air is forced around the tube applying pressure 360 degrees. This is far more rigid and stable - any deviation in air pressure at any point is met with a correcting force on the other side.

Not all "tube" air bearing arms are fully captured. Some have air holes only on the top side, which means there is no resistance to bottoming out.

I have an issue with arms like the Rockport & Kuzma where the air is forced into the moving arm - in my view this must play havoc with tracking force at a micro level because the plastic air hose will try to straight out under pressure, hence exerting vertical pressure on the arm.

With the Eminent Technology the air is piped into the manifold. There are no air lines connected to the moving arm/spindle.

@ledoux1238

If you really want to make a substantial upgrade to your front end you should investigate the Eminent Technology ET2/ET2.5 - even an old ET2 low pressure will trounce the Terminator - I’ve heard both - there is no comparison.

The ET has a decoupled counterweight system that can be tuned to the cartridge compliance - you can run anything on it from Decca's to high compliance Shure V15's.