Upgrading from Primaluna

Ignore any of the posts that are off topic. Your question was about maybe trying a bhk essentially, I say maybe build a short list of more powerful amps both ss and tubed and find a way to try a couple. Those other posts are full of assumptions.

I think you could benefit from moving your speaker outwards and revisit your front end components. Maybe even going to a speaker that fits your room better. 

…Those other posts are full of assumptions

respectfully I would submit that determining the SPL and maximum power the OP is using currently, would be germane as to whether more power is needed.

Like the OP, I too have a Dialogue Premium HP. It seems to pump out 90 dB(A) as measured with an iPad NIOSH app, at ~9’ in a room that is big in spatial volume… and it sounds “o’roight” doing so.
And my speakers are perhaps a bit less efficient than the OP’s??

There are 2 problems with those Sopra 2 speakers:

1. The load is a bit difficult to drive as. It is low impedance and also the phase angle gets high.
2. The distortion is low, which is good. So they tend have a bit of a quiet sound, and to me they begged for the volume to be turned up.

(When I heard them, they did sound great.)
Hence - with the combo of 1 & 2, I would probably upgrade the amp first.

I assume that the OP is using the 4 ohm tap?
They may also benefit from a set of KT120s if they wanted to keep the PL amp.
Maybe that would allow them to punch a bit harder?

You could consider upgrading to a newer PL setup.  I bought EVO400 separates last fall, and I fall more in love with the whole rig every day.  Hoo whee!

2 ft from the side walls sound correct. However, that measurement should be from the tweeter or center of the speaker...not taken from the outside edge of the speaker. 

And yes, do add diffusion/absorption on the front wall and look at the ceiling as well. These will make the speakers 'see' your room as bigger.

Think of the front 1/3 of the space as the highest priority to 'soften' and diffuse.