I am advised that the Kabusa wire is without doubt the most flexible. It's copper. i am not pro-copper/pro-silver - I am wondering if the gauge is too small to run to the RCA plugs.
TONEARM REWIREE - DUMB QUESTION
I am thiking about re-wiring an arm myself from cartridge tags to phono plugs.
My questions are:
1. after exiting the arm does one solder a heavier gauge of cable to beef up the smaller cable
2. does one simply shield the cable on exiting the arm
3. any wire recommendations other than cardas which i understand are quite stiff
- ...
- 11 posts total
That stuff looks pretty good in terms of flexibility, but check out Audio Note AN-WIRE-300. It’s made from three strands of 0.0019" thick silver wire (half the thickness of the average human hair) and has 6 coats of polyurethane as insulation. It’s incredibly hard to work with, but I can’t imagine anything thinner or more flexible. I ran mine straight from the cartridge clips to phonostage RCAs. https://www.hificollective.co.uk/wire/audio-note-silver-internal-tone-arm-wire.html Here’s my wire next to a typical Bic ball point pen:
|
Wow @ketchup ketchup that’s thin… I see Cardas do a new ‘Clear’ wire which is supposed to be very flexible. out of interest does one run ground via the shielding or just a separate wire?
|
- 11 posts total