Cube Audio Nenuphar Single Driver Speaker (10 inch) TQWT Enclosure


Cube Audio (Poland) designs single drivers and single driver speakers. 

Principals are Grzegorz Rulka and Marek Kostrzyński.

Link to the Cube Audio Nenuphar (with F10 Neo driver) speaker page: 

https://www.cubeaudio.eu/cube-audio-nenuphar

Link to 6Moons review by Srajan Ebaen (August 2018):

https://6moons.com/audioreview_articles/cubeaudio2/

----------------------------------------

Parameters (from Cube Audio):

Power: 40 W

Efficiency: 92 dB

Frequency response: 30Hz - 18kHz ( 6db)*

Dimensions: 30 x 50 x 105 cm

Weight: 40 Kg


* Frequency response may vary and depends on room size and accompanying electronic equipment.
david_ten

Has anyone tried 2A3 amplifiers? I've tried a lot of different gear over the years but only heard a full Audio Note system before that was SET. 

Has anyone tried 2A3 amplifiers?

 

@eric5kim Eric, @riaa_award_collectors_on_facebook is correct.

I’m on my second set of 2A3 amps driving the Nenuphar V1s.

Questions?

@david_ten which 2A3 are you using? 
does it have enough headroom for large orchestral works/rock/electronic music? 
If listening at 88db need at least 10db of headroom for peaks  

Eric 

I can highly recommend using a TEKTRON 211 tube amp (integrated) with the Cube Audio Nenuphars! Before the TEKTRON I used a NAT Single HPS. The TEKTRON is much better!! This is an addictive combination!!