FWIW, if your going through the trouble of adding a line, add 2 to 4. Its not much more money and you will hear the difference.
I agree! I installed four dedicated lines one for each mono block amp, one for digital and one for analog.
Mike
What type of wire for dedicated 20A AC lines?
I’m about to have two 20A dedicated lines installed. What type of wire should I use? I know there are differences of opinion on whether to use 10 AWG or 12 AWG, however the link below makes a great case for using even 8 AWG solid core copper on longer runs like mine will be (50 ft), to ensure a lower resistance, lower voltage drop over the long run, and therefore more access to instantaneous current for my Gryphon Diablo 300. The wire would need to be stepped down to 10 AWG to connect with the receptacle. The article actually states that the thickness of the wire is more important than the fact that it is dedicated…
Assuming I want to follow this advice, which again makes sense to me, where would I find such wire to give to my electrician?
So here's a beginner's question. If you're putting in a dedicated 20amp line, or even 2 or 4 of them, and if there are no free spaces on the main breaker box panel that you currently have, do you also end up putting in a new larger panel? Does a sub-panel solve that? And what are the other upsides/downsides of a sub-panel? |
@ditusa , yes I was planning on installing two lines, and then playing around with what configuration sounds the best. For others to reference, I’ve read it’s important to have all of your lines on the same electrical phase. The electrician will know how to do this with your breaker panel, but probably won’t know to do it without being directed. |
I agree! FWIW: My four dedicated lines are not on the same electrical phase at the breaker panel. The best sounding configuration in my rig is what I posted above. Mike
|