KEF Ref 107 KUBE forces my power amp close.


I have bought a KEF Ref 107-1 in a very very good condition last month. Then I bought a SS power amp (Audionet Amp 1) and drive it from preamp out of my Primare I30 SS integrated amplifier. Everything was OK and also I was using KUBE without any problem. Then I decided to buy a tube preamp and problems started. When I connect whatever tube preamp then my power amp gives a strange noise and closes itself. From the signals, it says "high frequency oscillation error".

I tried many things and the only solution is NOT to connect KUBE. Without KUBE the system works flawlessly but if I connect the KUBE into the system then power amp closes itself again. I also tried many different tube preamps but the problem didn't change. As I said my SS integrated amp's pre out doesn't cause such a problem and I use both KUBE and my power amp with pleasure.

I'll greatly appreciate if you can say why KUBE might cause this error and what I should do to use KUBE without problem.

Thanks and Regards
airnotas
I tried the tape monitor loop and btw source & preamp but both ways failed and power amp closed.
You need to take the KUBE to someone who can test it for you to ensure that it is working properly.
That the KUBE works fine with the SS preamp and the tube preamp works fine without the KUBE suggests some sort of interaction, so I doubt checking either out separately will solve the problem. There are a number of fine SS preamps to choose among, so why fight the problem?

db
I think, as many other people do, tube preamps sounds better and sweeter than SS preamps. That's why I insist on the tube gadget. I've found a very clean CJ premier 17 LS2 with NOS tubes and I don't want to miss it. Finally I omitted the KUBE from the pre-power chain and that's just fine.

My technician who is also a very good music lover and audiophile, offered to put a capacitor in the KUBE and claims that it will resolve the issue but I didn't prefer this way.

Thanks for all your attention for the issue.