Grounding cable gauge size

tksteingraber,

Are you using it as chassis grounding?

ozzy

@ozzy not chassis grounded.  I have my amp, DAC, CD, blue ray player, sat Dish receiver and sub connected directly into components open RCA plugs to the RF Router double side posts (2 banana, 4 spade) The single post on the RF Router Is connected by spade to a wall power plug rewired with all 3 wires to the ground only and plugged into an outlet using the house ground wiring.  Not how Russ recommends but it’s working well for me.

tksteingraber,

Ok, I would call that signal grounding. I have mine routed to my Entreq/DIY units.

I am using the Russ Andrews device to the chassis of my Lumin X1 power supply and the chassis of my JL CR-1 crossover.

But whatever way improves the sound...

ozzy

I made order of components for DIY Ground Boxes. I would like to see comments from experienced users. 

Maybe something is superfluous or missing?

Not sure about using a magnetic mat. Has anyone tested its effect?

…

Oak box 6,6"x8,5"x4,6"

Entreq Slim Tungsten Feets

Viborg BP614R Cu(R) binding post

Silver Wire 4N 10AWG 

Copper Tape OFC 3N 

Copper Foil OFC 3N

Tungsten Foil 3N 

Application Stabilant with Graphene Powder

     Filling Diamagnetics, Piezo- and Pyroelectrics:

83% Schungite

10% Tourmaline

5% Rochelle salt 

3% Clear and Smoky Quartz

    Filling Mix Dia-, Para- and Ferromagnetics:

Copper 5N Cu OFC Granules 

Silver 4N, Copper 5N, Tungsten, Brass, Al, Mg, Fe and Steel Powder

drpie,

The reason I recommended the magnet mat at the bottom of the ingredients is to simulate the earth's natural magnetic pull.

I suppose if you are unsure, you can try it on the outside bottom of the box.

ozzy