How do I use the KEF Kube 2 w/ my Denon receiver?

Use one of the receiver's tape monitor loops. Connect the receiver's "Tape out" jacks to the Kube's "In" jacks. Connect the Kube's "Out" jacks to the receiver's "Tape In" jacks. When you want the Kube to equalize the sound of your KEF speakers, turn your receiver's "Tape Monitor" or "Tape Mon" loop to "On" or "In", depending on how it's worded on your receiver.

Johnny,
Thank you for answering my question and trying to help me! I have a few clarifications and follow up questions.

On the back of my Denon receiver I have a place called "Tape 1" below it are 4 connector holes top two are white bottom two are red. The left top and bottom holes say "PB" the right 2 say "Rec"

Is my Tape 1 the correct "Tape out" area?
Is" PB " the "i"n and "Rec" the "out"? Do I use red or white?

On my Kube I have a "signal" in and out and a "Tape" in and out, which do I use?

On the front of my Denon receiver I have "Rec out select", T.Mode, and FM Mode.which is the "Tape Mon"?

On the front of the Kube I have a "contour" dial, and "extend" and "tape" buttons. What do I do with these?

And my final painfully simple question is when I go to the Radio Shack and buy connectors is there a specific kind I ask for?

Thank you again!
h

Rec = tape out = connect to Kube's input.

PB = Playback = connect to Kube's output.

Red = right channel; white = left channel. You need both for stereo.

To have the Kube in circuit to flatten and extend the response of your KEFs, push the Tape button on the front panel.