Advice for mounting a TT shelf on a wall

Thanks for the posts guys, it points me in the right direction. Fortunately, I will be mounting it on a load bearing wall. Am I correct in assuming that half way up the wall may be another room node? I know to keep away from corners and other electronics. Want to get it as right as I can the first time.

 Matt, I misread your post and had to laugh. I read, mount it on a short door.  To each their own. Fortunately no one recommended a ceiling mount.

A load bearing 'outer wall'.

Preferably with no doors opening

and shutting into a door frame or

stairs attached to that wall.

Hit both studs dead center and

If your handy enough open a horizontal

slot between both studs and brace the

two studs together then use that

as a third spot to attach shelf. The

shelf itself will hide most of your drywall

repairs in any event. No corners as your 

aware.

@4krowme 

Am I correct in assuming that half way up the wall may be another room node?

As I've got older I find the optimum height is high enough so you don't have to bend over when placing records on the platter, and also such that you can look at and clean the stylus comfortably - for me that's about hip level. Forget about room node for height  - bit OTT in my view.

Mount it away from the corners of the room.

This is a must to consider because of low frequency feedback. A corner can be a bass trap. This happened with my wall shelf and it was a pain to get rid of.

Mount it where it’s comfortable to use or you will stop using it. I agree with not putting it in a corner, but other than that, I don’t think it’s that critical unless you have a very large system played at loud volumes.