What Power Cords for Rel S510 Subs?

My speakers are Sabrina X and I currently have Venom. They will be replaced tomorrow with Venom NR. The contribution from my subs are intentionally limited. If I raise the volume, or crossover point, the Sabrinas get a bit muddy. Honestly, I never removed the REL power cables from their plastic bag. I just started building this system a few months ago, so for me I have other $ priorities..like a much higher end phono preamp. I won’t be putting more money into my subs. PM me and I can connect you with my salesperson that can usually provide 60 day in home returns, plus good pricing and you can do the A/B yourself. All my interconnect are AQ.. BTW..The power conditioner was the most critical component in my system.  Room treatment equally critical.

Or support an American small business like Signal  Cable. 

Perfect for a subwoofer.  I use the Silver Resolution on all my components except my DAC and CD Transport there I am using the MagicPower Digital Reference.  

Also check out Zavfino USA. I have their speaker cables and interconnects. Top shelf stuff.

http://signalcable.com/magicpower.html

@vonhelmholtz nice system.  I like Wilson speakers a lot.  i am not looking for bone rattling bass.  Just a bit of added support for my B&W 802's, in my large room with high ceilings.

I think how you described the setup of your Rel's is exactly how you are supposed to have them set up.  Crossover set lower to seamlessly integrate, with subtle boosting of the low end.

Are you finding your Rel's to fill in the lower frequencies sufficiently?  Or are  you finding that your Sabrina X's are still thin in their lower range, before the Rel's kick in?  Do the Rel's seem to integrate well and provide the bass energy and extension you were after, or do you think the bass could have been better somehow?

My primary speakers were not really lacking anything, but with the RELs when I play The Doors, Cantate Domino, or many jazz pieces, the reproduction is fuller with more impact. My room isn’t that large..12.5x23x10 and the room is on the second floor, so I had big problems with bass/cartridge interaction. After nine large bass traps, I finally managed to get this mostly under control. I have a four shelf 3" Tiger Maple equipment stand coming and I hope this, along with the 108 pd integrated amp will take care of any remaining bass issues.

I replaced the power cord on my s/812 with synergistic research. I also did the same with the fuse. I added a SR ground wire from the sub to my ground block as well. I have my whole rig set up this way and its amazeballz