Atma-Sphere Class D… Amazing


Today I picked up my Atma-Sphere Class D Amps. These aren’t broken in yet. And they are simply amazing. I’ve listen to a lot of High End Class D. Some that cost many times what Atma-Sphere Class D costs. I wasn’t a fan of any of them. But these amps are amazing. I really expected to hate them. So my expectations were low. The Details are of what I’ve never heard from any other amps. They are extremely neutral. To say the realism is is extremely good is a gross understatement. They are so transparent it’s scary. These amps just grab you and suck you into the music. After I live with them some and get them broken in. And do some comparisons to some other high end Amps Solid State, Tubes and Class D’s, also in other systems I’ll do a more comprehensive review. But for now, these are simply amazing amps.. Congrats to Ralph and his team. You guys nailed on these.

 

 

128x128pstores

So here is a question, @kuribo has gone hard at the aforementioned amplifiers built by Ralph and his fine company, question is have you an opinion (yep regret that now) on the AGD GaN mono blocks? 

@juanmanuelfangioii

If one can get past the aethetics/gimmickry, this is what a reviewer had to say about the $20,000US version:

"output impedance [dashed trace, see Graph, above] rises steeply at HF, as does distortion, while the frequency response varies with speaker load impedance [unloaded/8/4/2/1ohm = grey/black/red/blue/green traces]. Put simply, if the impedance trend of your speakers rises in the treble then the Gran Vivace will likely sound brighter, and vice-versa.."

"a marked increase in THD into loads below 4ohm – typically >0.1% from 1-100W/2ohm versus 0.002-0.08% into 8ohm. Under continuous conditions, distortion increases from 0.004%/1W, 0.005%/10W and 0.09%/100W (all at 1kHz). Distortion also increases with frequency [see Graph 2, below] from 0.005%/1kHz to 0.07%/10kHz and 0.3%/20kHz (all at 10W/8ohm) in line with the response of the reactive output filter network."

The switching frequency is 800Khz, a bit higher than what most using silicon mosfets use (600Khz or so) but not really high enough to take meaningful advantage of the benefits of GaN mosfets. The Techniques GaN, for comparison, switches at 1.5mhz.

Load dependency is a non-starter for me. I wouldn’t call the performance "state of the art".

At $20,000US, for a shiny aluminum box and a fake tube, with performance bettered by amps at 1/20th the price, I can find little to attract me for a listen.

@kuribo 

You are welcome anytime to visit us at the next Audio Show and listen to our amps and then corroborate or revisit your assumptions. However as a matter of curiosity, is there a reason why in your peculiar selective cut&paste exercise you decided to omitt what in the same article the reviewer wrote about the sonic qualities and his personal experience about the sound?