Most of the older two prong corded equipment is double insulated, even some modern stuff such as my marantz avr is double insulated with a two prong cord, so it can be perfectly safe. I'm not saying the carver crimson amps are safe as I haven't looked at them.
Owners of Carver Crimson 275 -Caution/Warning--Potential Increased Risk of Electric Shock
What's going on?: If you own a Carver Crimson 275 amplifier there is a real potential that your amplifier does not have a proper chassis grounding scheme inside. There is a type of grounding system involved, but the third prong of the IEC socket (the actual electrical socket on the inside of the amplifier) is left wide open on my amplifier and and at least one other amp that I have virtually confirmed (not firsthand--only through another owner).
What does this mean?: If one of the hookup wires carrying power/B+ came loose from its soldered weld and touched either the chassis or something conductive to the chassis and the user then touched the chassis/unit with the power on they could get a significant electric shock. There are some seriously high voltages in this tube amp (like many amps of its topology) and the result could be lethal.
Carver Corporation's Response to Status on Grounding: I have notified Frank Malitz of the Carver Corporation about this problem. He responded to me in writing saying the following, exact quotation, nothing more or less:
"the design is under review with engineering and I'll contact you tomorrow." (F. Malitz)
In the interim, users may be at an increased risk of shock and bodily harm. I would encourage you to check with an electronics expert or the Carver Corporation for further guidance, as I'm not qualified to say more than there's no confirmed chassis ground in the unit that I have and at least one other unit.
Finally, unless you are qualified in working with high voltages do not open your unit to check for the ground wire running to the ground prong on the IEC. Please note that doing so with or without a chassis ground should only be done by someone experienced with electronics--i.e. caps must be discharged and care taken to cause an issue. Seek professional help.
I'm just a music lover and hobbyist. I'm merely relaying this information out of concern for the safety of fellow humans. I'm not an expert and perhaps an expert will rule out this identified potential increased risk as non-existent. For now, I can say that it is my opinion that there is a real reason to believe that grounding scheme might be deficient and I will not be using my amp until this is sorted out.
I'll report any response from the Carver Corporation as soon as I hear back. For now, my amp will sit unplugged.
- ...
- 99 posts total
- 99 posts total