Rives PARC parametric equalizer

My PARC is also fed by Exactpower EP 15A. I dont know if it may affect PARC adversely. Anyway in this configuration, and to my ears, attentuation of bass boom not withstanding, the PARC is not transparent compared to if it is out of the chain. A good PC certainly helps to close the gap though.

There is another thread at the moment that speculates how mid range can affect bass perception ....perhaps it also works in reverse too...

....all the same I am puzzled by what you both report but I don't doubt your observations.

Here is the link

I don't think the article is applicable since I can obtain the bass benfefits of the PARC and avoid the midrange problems just by routing the midrange to physically bypass the PARC. I don't believe the physical bypass is equivalent to the PARC's circuit bypass.

Dotsystem is right in that the PARC bypass goes from an input across a relay to an output. If the PARC is totally out of the system you avoid the relay and the additional connection. My point about the test was assume that you must have the connection and yes, that is one more connection and one more opportunity for signal degredation, then what is the PARC doing to the signal once you've made that connection.

Doing what Dotsystem does, i.e., "The preamp signal sent for the midrange and treble amp does not pass through the PARC" would cause a time-delay in the bass section, wouldn't it?

How can a person compensate? Please advise...