I recently purchased 4 of the horizontal lettering tubes for my Atmasphere MP-1
Did you use socket savers? no chance you could fit all 6 tubes right?
Linlai E 6sn7 tubes
I just placed an order for a pair of these for my Aric Audio Motherlode II. I’ve been chatting with a fellow that runs the E 6sn7 in his Don Sachs pre. He loves them, He says they make his NOS tubes sound thin and lifeless.
It will be a couple weeks until I receive them,and I was curious if anyone out in Agon land has tried these,and what are your impressions?
Thanks in advance,
Ray
- ...
- 805 posts total
The Linlai Global Elite E-6SN7 are 56mm in diameter, or 2 3/16". Measure from center of socket outward half the distance of either those two measurements leaving enough clearance for neighboring 6SN7. I believe that clearance to be .5mm or .65mm Important note: also keep in mind your top plate clearance, the chassis. And hopefully someone will chime in with some Cary SLP-98 experience. |
@borisj, my bad. Recommended clearance between both valves 1cm or 10mm or roughly 3/8" |
- 805 posts total