Bi-Wiring
Although the option to do so is there, I hadn't planned on bi-wiring my speakers, especially after watching this: https://www.youtube.com/watch?v=McH2tlfj0vo
In the video it only speaks of bi-wiring on the speaker side (and a bit about bi-amping). But my amp has two sets of binding post for each channel as shown here: https://coda.cc/coda-no-8-amplifier
I have reached out to both my dealer and the manufacturer about this with no response as of yet, so I was looking to you all for what your thoughts are on this?
Will running 2 pairs of speaker wires to the 4 individual binding post do anything for me or would the info in the video still prevail? Thanks!
For me whenever I have tried bi-wirng having 2 sets of bindings posts on your amp makes things a bit easier particularly if you hardwire (not using banana plugs or spades). In my experience what I have found is that a single run of a good cable using the same cable as jumpers on your speakers, outperforms actually bi-wirng with a lesser cables. |
OK then, for a single channel there are 4 binding posts on the speaker and 4 corresponding binding posts on each speaker. Keeping the phase in check, does it matter, or make a difference on which of the binding post use on the amp to correspond to the binding post on the speaker Or is it just common sense upper to upper and lower to lower? |
@jl35 - OK, thanks! |
