2. analog
  3. 183894-181810

Music Hall Classic humming issue

Just purchased a Music Hall Classic off this site. Hooked it up to Kanto YU6 speakers using the built in pre-amp and I’m getting a 60 cycle hum that, through process of elimination, I’ve determined is coming from the turntable. Checked/swapped out wires, checked outlets, ground wires are set…hum is still there as soon as I turn on the turntable. Any ideas? Would going through an external pre-amp eliminate that? Thanks!
fredb72
williewonka
3,082 posts
 

@fredb72 - what's youe setup - e.g.

  • Cartridge
  • phono amp or pre-amp/amp with phono
  • cable from turntable into phono input

Hum can be very difficult to get rid of and can be due to

  • the cables from the turntable
  • the grounding on the arm
  • the phono stage (when it has a 2 prong plug or wal-wart supply)

Regards - Steve

fredb72 OP
2 posts
 

@jea48 Thanks! I think you nailed it with the EMI from the power cord. Even moving the power cord to the lower outlet on the wall made a difference and then as I experimented moving the TT farther away from the speakers, the hum lowered. So I think I’ll need to run an extension cord to an outlet further away from the TT and hopefully that should do the trick!

jea48
4,476 posts
 

@fredb72

It sounds like the EMI (Electric/Magnetic fields from the 120V unshielded power cord that feeds the amplifier of the Kanto YU6 is inducing 60Hz EMI noise on the DC power cable that feeds the phono preamp in the TT. There could also be AC noise going back out on the 120Vac power cord caused from the power supply in the Kanto YU6 amp.

I would try to keep the TT as far as possible from the Kanto YU6 amp. I would also suggest you try, buy, a shielded power cord for the Kanto YU6 amp.

Example:

I found this cheap one doing a search on Google. How well is it shielded??? Don’t know...

.

NEMA 5-15P to IEC C13 Shielded Power Cable - 14AWG STJ

https://cablechum.com/products/nema-5-15p-to-iec-c13-shielded-power-cable-14awg-sjt?variant=39782258381

$11.35 CAD + shipping.

You may find something cheaper. Note, lots of cheap 18AWG shielded power cords but hard to find any wire size bigger than shielded 18AWG.

Step up to aftermarket audio grade shielded power cords and the price jumps up sharply.

 

FWIW, an outboard phono preamp might make a difference. Not sure it would be worth spending money to find out though.

 

.

More to discover