Cable elevators


My Saturday hifi tweaking involved digging out the family’s box of wooden building blocks and using them to elevate my speaker cables off the floor. Previously under an area carpet on a wood floor. Mc 601s to SF Amati with Wireworld speaker cables (to be replaced with Cardas). 
 

The result—mind you the system is playing really well right now thanks to my new Cardas interconnects—is greater clarity (I think), sound stage, and texture. This is definitely about wringing out the last ounce of the system and maybe I’m imagining the improvement. I don’t think I’d spend any money on buying risers, but what the hell why not use the old building block. Looks dopey and the family laughs at me, but dang does the system sound amazing.

Anyone else play with risers/elevators?

w123ale

Impress your friends. Use Champaign goblets.  Glass is an even better and more consistent dielectric. Just don't admit they came from Ikea for $12 a 6-pack as of course, they can't sound as good as Waterloo crystal.  :) 

In reality, if you believe they sound better, it is your enjoyment that matters.  In the world where physics still rules, maybe if you were on a steel raised floor ( computer room) and ran hundreds of feet, with too-thin insulation, OK, maybe it does not violate any laws.    Full disclosure: I run 12 gauge twisted pair with pretty thick vinyl insulation. Only about 8 feet.  I have heard differences, but only in fancy cables screwing up. Shielded cables for instance have much higher capacitance and in a long run can, can, roll off the top end. Maybe.   Twisted Zip cord is near perfect for speaker cables. Funny, the original Monster cable was actually very good. 11 gauge, twisted, thick insulation. 

Yes, at RF frequencies, a lot matters. Speakers do not respond to RF. SWR in a speaker, ( fractional Ohms into several) also do not matter in AF.*  Do not fall for salesmanship that take valid physics from a different a domain and try to apply it to audio. 

There is a HUGE amount of money that can be spent that actually damages the sound less in speakers, amplifiers, DACs, and of course the room than thinking magic tweaks will help. I really want to hear an Aries II in my system to see if it is any smoother than the Atom+ as far as female vocal sibilance.  So far, no one has beat it. ( thanks Amazon returns) Clear, audible, repeatable differences. 

* I had an odd case. Amp had no RF filter in the output. No Zobel.  Long cables. A yahoo with a 1000W CB radio in his truck blew my tweeters as the RF was picked up by the cables, detected by the amp feedback and amplified. A set of Kimber cables made it sufficiently immune.  Then I solved the root of the problem when I identified the truck.  A strait pin can do wonders when pressed through a coax. So, defective amp design, illegal transmitter and a real problem.  Hack ( cable) mitigated until I fixed both root problems with a better amp and "fixed" his footwarmer. The good outcome was the Seas tweeters I used to replace the T-2000's were much nicer. 

https://positive-feedback.com/audio-discourse/bunking-cable-lifters/

 

On positive feedback there is an article on bunking cable lifters, they actually measured a difference in capacitance with cable lifters in place.

I once saw a video where it was demonstrated that the more cable was lifted off the floor, the less capacitance was measured. I have yet to try them myself but I expect, if a difference is so easily measured, there's every likelihood (providing your system is sufficiently revealing) one might here a difference, whether an inprivement or degradation. Personally, like others here, if I decide to experiment it will be with scrap pieces of wood or other items I already have rather than spending a small fortune.

and since many of these risers are free, no need for the snake oil accusing  people to worry...you hear a difference or you don't...