Marantz 2325 speaker cables

I've always liked Mapleshade speaker cables with vintage receivers...

What is your budget? What model are the speakers?

nandoe67 OP Just add solder to the stripped ends! You can get a basic soldering iron and solder for $10-$20!  If you haven't soldered before, the learning process is as easy as a few tries on a practice piece of wire.

The speakers are PSB 600 tower speakers. 

Get 4 of the angled pin connectors (see link) for the rear of your Marantz. Then strip 1" off the speaker end, unscrew the nuts on the binding posts and expose the hole in the shaft, twist and insert the wire into the hole in the center of the binding post shaft, tighten them good by hand. Use 12 or 14 gauge all copper, made in the USA speaker cable. Try not to buy speaker cable made in China.