Wide bandwidth = necessary?


Hi folks, there is one paradigm that bothers me a bit: many experts and audiophiles are stating that Red Book technology is outdated because of it's bandwidth limited function. I've read the human ear is capable of perception of frequencies beyond the normal human hearing, up to 40kHz. But this is only with live music! When listening to recorded music there is a restricted bandwidth because many microphones can only pick up frequencies up to 20kHz. So why the need for more and more bandwidth with regard to digital sound reproduction technology? What is not present in the recording can't be heard either, even with very wide bandwidth music reproduction gear.
What is also laughable is that many vinyl adepts say that phono playback gear can reproduce tones as high as 40kHz and that is one of the reasons phono playback sounds more "natural" than digital playback. This is a bit of a contradictio in terminis because most LP's are very band limited (30Hz to 16kHz is quite common). Your comments please.

Chris
dazzdax
Amazing! Thank you for the references. Still I can't understand the need for such a response (to 40kHz) while during recording the bandwidth is limited.

Chris
For those who haven't looked at it, I think that Stefanl's link is an excellent and very in-point medical/scientific paper. It documents a study in which "non-stationary" ultra-sonic sounds increased pleasurable brain activity in the test subjects, but only when sounds within the normal audio spectrum were simultaneously present. "We conclude, therefore, that inaudible high-frequency sounds with a nonstationary structure may cause non-negligible effects on the human brain when coexisting with audible low-frequency sounds."

So it would seem like ultra-sonic frequencies can be "audible," but only as a result of some intermodulation process with lower frequencies, or else, as the paper put it, "participation of nonauditory sensory systems such as somatosensory perception also needs to be considered in further investigations."

Still I can't understand the need for such a response (to 40kHz) while during recording the bandwidth is limited.

I'm not particularly familiar with the roll-off characteristics of professional recording microphones, but I would expect that although their bandwidth may only be specified to 20kHz in many cases, the roll-off would be gentle enough to capture significant content well above that frequency, assuming it is present.

So, if you are want to transport a 16-b word of music @ a 44.1KHz rate - this is what a CD laser mechanism does: every 1/44.1KHz seconds it spits out a 16-b word read off the physical spinning CD - you would have to transport each bit in 1/(16-b * 44.1KHz = 705.6KHz) seconds (so that you are ready to transport the next 16-b word that will arrive 1/44.1KHz seconds later.
So, your USB cable needs to have 705.6KHz bandwidth (& your DAC needs to run at 2*705.6KHz, as per Nyquist's criteria).

Keep in mind that two channels are present. That is the reason for the factor of 2 (which actually will be a little greater than 2 because additional non-data bits are needed to support the communication protocol).

Also, I'm not sure it's clear to everyone that the Nyquist criteria (sampled data systems being able to handle frequencies no higher than 1/2 the sample rate) does not relate to filtering at the output of a dac. Ultra-sonic spectral components that are present at the output of the dac chip itself, due to the 44.1kHz sample rate, will not alias, or "fold-down" to lower frequencies. A brick-wall anti-aliasing filter, which as I mentioned is needed at the input to an a/d, is not needed at the output of a d/a, even a non-oversampling d/a running at 44.1kHz. The spectral components associated with the sampling will be at frequencies of 44.1kHz and its harmonics (88.2, etc.), or at much higher frequencies if oversampling is used. They needn't necessarily even be filtered at all (consistent with Paulfolbrecht's comment), or if they are filtered the roll-off can be gentle.

Re Paul's comment about the desirability of no filtering, btw, I would expect that to be dependent on the specific components (preamp, power amp, speakers) that are being driven by the signal (particularly their bandwidths and their sensitivities to intermodulation distortion at high frequencies).

Regards,
-- Al
Bandwidth is not limited,which John Atkinson illustrates here, http://stereophile.com/features/282/ He closely looks at the very issue of what is captured on vinyl.Doug Rife postulates a theory of why this is important, http://www.mlssa.com/pdf/Upsampling-theory-rev-2.pdf both of these articles are good reading if you are interested and James Boyk's work at the Caltech Institute http://www.cco.caltech.edu/~boyk/spectra/spectra.htm looked at what ultrasonic content is captured by microphones until the signal starts to break-up at around 50Khz.
Chris, I obviously misinterpretted what you intended to discuss in this thread! :-( That makes my long rambling post irrelevant. Please ignore it. Thanks.