Benchmark DAC1 configuration

Lots of options for output from a Benchmark DAC. It has both RCA and XLR outputs. And you can set the output to be a fixed level, like any regular CD player or any any other component. Or it can give you a variable output that goes through the front volume control like the output from a preamp. Selecting variable or fixed output is done with the small switch on the back - down for variable or up for fixed.

If you are connecting to an integrated amp, you would probably want to use the fixed output setting and let the integrated amp control the volume. If you were connecting it to a power amp (no volume contol on the amp) you would want to use the variable output setting. Make sure you start with the front volume control turned down in that case. The headphone jacks on the front of the DAC1 go through the volume control knob no matter what the setting on the back.

As far as digital inputs, that will depend on what kind of digital output(s) you have on your transport. You can find different opinions on which input is the best. I used the SPD/IF (BNC) input when I had a DAC 1. SPD/IF will come out of most transports with a RCA type connector. The DAC 1 should have a RCA/BNC converter included with it. Or do like I did and get a digital cable with RCA on one end and BNC on the other end.

Thanks so much, each of you, for responding. It really helps and is much appreciated.

Almarg, I just wanted to see if anyone has bypassed their preamp stage in a tube integrated with the DAC1; wondered if it performed better than one's integrated pre. Also, duh on my part; I wrote the transport part wrong (but I appreciate the correction). As for your clarifying paragraph regarding comparison purposes, that was really very helpful. I just couldn't logistically figure how this would be connected. However, I do see what you're saying, and I certainly do not wish to introduce interference of any kind. I've read people using it as a preamp with good results; but as a DAC, it's been well-received, too. I guess I wanted to hear if people had any comparisons between the two configurations secondarily, but the "how-to" first and foremost.

So with that, maybe it's just simplest (cable-wise — both sheer number-wise used in conjunction with different types) to use it as a DAC, and choose a good digital (as my CD player is a Cambridge Audio 740C) cable as Sonofnorway has illustrated. I have several types of cables, but use AP Solo Crystal Ovals throughout. So, maybe an AP Digital Oval cable would work well (this is where brands would be welcome from anyone).

Sonofnorway...we'll talk offline (sent you an e-mail).
Thanks again everyone!

JSawyer09 -- You're welcome!

As you probably realize, you would only be able to truly bypass the preamp stage in the integrated amp if it provides preamp-out and power amp-in jacks on its rear panel. These would normally be jumpered together, and to bypass the preamp stage you would remove those jumpers and connect the dac1 output to the power amp-in jacks. Many (most?) integrateds don't provide those jacks, though.

If you wish to do so, there would be no harm in trying the setup I described with cd player analog outputs and dac1 analog outputs both connected to line-level inputs of the amplifier. That will most probably work ok, as I indicated, and if hum problems resulted they would be immediately apparent.

Regards,
-- Al

You are welcome.