DCS reading problem


I recently aquired a DCS Elgar plus and La Scala. My La Scala seems to have problem reading disc. After many trails and erros, I realise that it could only ready SACD Dics amd had problem reading CDs. Can anyone pls tell me if this is the problem with my player or with my connection?

Thanks in advance.

Regards,
KC
kctan
Kctan,
Your problem sounds familiar.. With mine, symptoms were at times my Verdi would just read the sacds, and on another, quite the reversal--reading only red books. Error or toc kept appearing when playing the sacds, then finally '0' on the display. Might just be a case of bad optic (wear and tear). Had mine replaced 3x in the span of 6yrs. More likely to happen if you do not use the unit much or through humidity or so I was told.

Purchased from dCS the whole optical assy (parts only) costs 450 pounds (3-4yrs ago). In fact it's a Sony unit they are using, so for my 2nd and 3rd replacements I sourced them direct from a local Sony authorized and had my technician friend do it. All up it cost me around U$D100--so quite a saving there. Parts code are : Device, Optical KHM-230AAA, SCD-333ES, Sony. Hope this helps.
Bvdiman

thanks very much your adv. Will try and see if i can find the Optical pick up and get someone to replace it for me. Thanks your advise, Hope it works this time.
The KHM-230AA unit is used in a lot of players. The quality control of these units is not the best and they can go bad in a short amount of time. The only solution is to replace and hope for the best.
I guess that's why dCS opted to use Esoteric units in their latter transports. But when committed to the 'old stack' there's no other way going about this routine maintenance (I consulted dCS direct). Anyhow, they are quite readily available and not too costly too. A good optical assembly in my experience will last at least 3yrs.

Kctan, if you decide to have just a technician do it, best if you can ask from dCS an instruction sheet (comes with my first factory unit). A clear step by step guide on how to replace them--quite essential actually. As I recalled, there's a solder point which needs to be 'thoroughly cleansed' during the process before your La Scala be able to read any SACDs. Good luck!
Thanks Bvdiman for advise> To be on the safe side, have arranged to send the player to the agent for replacement of the optical assy.