2. tech-talk
  3. 1123883453

Running supply voltage of 60/60 - Vs - 120/Neutral

With the power system im running now, it supplys power at 60 volts and 60 volts each leg, Versus the nominal 120 volt and neautral, im curious as to what the benifits and problems that this may cause for audio equipment, with running no neutral, i get this off of the isolation transformer, as part af a large power system with battery backup to insure than nothing frys in the event of surges and electrical storms, could this possibly cause a better "balance" and maybee increas audio quality? it's definatly a safer system as you would not get shocked unless you touched both legs at the same time.
archangelluke
bob_bundus
1,834 posts
 
Hi Sean it appears that Luke already has his balanced power setup in place; BTW isn't your own AC supplied via a balancing transformer? I recall your traveling to (Ohio was it?) a couple of years ago due to a bargain find on 2kva transformers. Wish that I had been working at the time but I was off for a year updating my data networking education; otherwise I would have liked to try one! So Luke if your reserach dictates that you'd be better off without then please do let me know...
Post removed 
archangelluke OP
14 posts
 
The grounding system i am using is a common all across system, so the primary and the secondary ground is the same, with normal outlet ground, i am having trouble with ac noise, on my sub (sunfire) it has a humm without any inputs attached, the grounding system may be the reason for it.

heres a pick for one of the transformers i am using, wich is dedicated to my sunfire sub, as it draws up to 2700 watts of ac power:

http://cgim.audiogon.com/cgi-bin/vs.pl?vstrt&1120471223&viewitem&o6

The input has been config for 240v in as thats what my apc runs on, and output taps 5 and 8, this system was made to be tough,mainly becaus of the sunfire high current draw.

Thank you for your help, i will keep posting on this thread as we discuss this matter,
Post removed 
sean
6,231 posts
 
Some of the Sunfire subs are notorious for being noisy. You should contact Sunfire about this problem and discuss it directly with them.

As to the isolation transformer pictured, it looks WAY too small to pass 2000 KVA with low distortion. Then again, it is hard to judge how big the core actually is going by that picture, as there are only the wires and heads of the bolts holding it together to gauge the physical features by. This wouldn't introduce hum into the sub at idle, but it could introduce other distortions at higher power demands. Sean
>
More to discover