Borresen X3 measurements

I am in as soon as they plug that hole in the midrange.

Erin's results on the X3 is odd or at least unusual. Not flat responses are not that unusual by designers' choice, budget and performance/cost tradeoffs, or QC fails to name a few possible causes. What I am puzzled about is the ~12 dB suck out then peak between 200-350 Hz. Something (perhaps woofers' mechanics or enclosure?) is in a sharp undamped resonance condition.

This also shows up in the Cumulative Spectral Decay plot.

Just nerding out on what is the source of that resonance still ringing along 20 mS after test impulse is done.

Ouch, the forum's auto image reformat of frequency response plots from landscape to square really exarated dB scale. See originale here:

Erin's Audio Corner Børresen X3 Floorstanding Speaker Review

Did AGD/Borresen address these findings?  Curious to see what they have to say and even better if they can produce their own related measurements.

in response to dayglow...

As I stated above indeed the cabinets are made in China but all drivers and assembly of such are done in Denmark