I have the Weiss 204 with a sbooster LPSU upgrade. I believe sound wise it was a substantial upgrade over the qutest (I have it for test with a upgraded power supply too) and the Weiss 204 with the LPSU is just a tad bit behind the Holo May KTE in resolution and a bit of nuance in the lower registers. Overall very happy with the Weiss and can recommend it without reservations.
IS THE WEISS 204 A SUBSTANIAL UPGRADE FRON THE CHORD QUTEST
My system is as follows:
- Martin Logan 11A Impressions loudspeakers
- SVS SB-4000 pair of subwoofers
- Chord Qutest Dac
- Lumin U2 mini streamer
- Bryston 4B3 cubed power amp-500/ channel into 4 ohms.
- Rogue Audio RP-1 preamp, Bryston BP-19 preamp on order.
- Seeking a DAC with higher resolution than my Chord Qutest. maximum budget is $5000.00
- Question: Would the Weiss 204 be a substantial upgrade over the Qutest? The Weiss would come in at $3500.00 plus $1000 for
- Modright Linear Power supply addition. Not looking to go sideways or only receive a small improvement. The Weiss all in is three times the price of the Chord.
- Thank you in advance for any guidance you can offer.
- ...
- 16 posts total
@panzrwagn got it. Thanks for the system compliments if they were directed to me. Happy Holidays to you! |
I think I wasn’t clear in what I was saying. The job of a DAC is to convert the digital bitstream input into an analog output. All DACs must do that identically or the ones at variance are defective. But that part of the job is incomplete. The signal must then pass through reconstruction filters, then passed through an analog line stage before one can listen. The reconsruction filter used in a digital to analog converter that eliminates the stair-stepped waveforms created in the digital sampling process and restores frequency, amplitude, and phase of the original signal. The process of digital sampling creates stair-stepped waveforms that resemble square waves (increasingly so at higher frequencies). These waveforms contain the original signal, but also have high frequency noise and harmonics added to it. The reconstruction filter – which is basically a low pass filter – removes all of the high frequency signal above the Nyquist frequency that was induced because of the sampling process, leaving a “smooth” sinusoidal type waveform resembling the signal that was originally sampled. lAnd it is in those stages that the differences in sound quality originate, not in the DAC stage itself. It is our tendency to group those stages and refer to it as the DAC. The difference is not just semantic, rather it enables us to focus the discussion on those areas that actually can impact sound quality. https://support.auralic.com/hc/en-us/articles/206806457-What-s-the-Difference-Between-PCM-and-DSD#:~:text=A%20reconstruction%20filter%20is%20typically%20used%20in,are%20normally%20used%20in%20PCM%20encoding%20systems.&text=The%20dynamic%20range%20of%20DSD%20decreases%20quickly,rising%20noise%20floor%20just%20above%2020%20kHz. |
- 16 posts total