Im going to regret my cable question

I am rather certain my amp has more than enough power. The speakers [4 Ohms]  are rated at 250 RMS. Amp requirements are 100-250 W. All as per manual specs. Michi pumps out 350 into 4 Ohm. So no worries there.

I also contacted both companies directly to confirm the match prior to purchase. Both said it was a perfect match. In fact higher power from the amp is safer than less, as per both contacts at both companies. [Which we all know]

Cartridge compliance?? What? I stick a Rega cart. on my Rega arm. No brainer there. 

Its almost as you are trying to wind me up.

Not at all. I assumed your amp was the Line Magnetic SET so I must have confused this with another thread. 

@squared80  Bingo…we have a winner !

Cheers 

For not.

Any part matters in analog circuit BUT it depends on the circuit how much does it matter. For example, simple old tube schematics (Audio Note) will depend on cables way more than (most) modern solid state. But there are different solid state designs too, so... Someone's experience won't necessary apply to you.

Ethernet cables are all the same though.