Just got a new power amp

When single ended rca is compared to balanced XLR, how many people are actually taking voltage measurements to level match each one?

I would guess that most either don't try and match it or do it by ear.  When I tested it, I used a SPL meter and a white noise test tone.  Not exact, but very, very close.

PS Audio S300 is not fully balanced. "Bridged" output might suggest that, but it isn't a bridge of two amps but 4 Mosfet bridge to flip speaker direction between V+ and GND, since output is single voltage supplied.  Some class D modules, like Hypex, use dual +/- supply and only 2 output Mosfets.  S300 is based on 300AS1 Icepower module, almost identical to 200ASC (in my Rowland 102), but  with stronger output Mosfets.  Both my amps Benchmark AHB2 and Rowland 102  don't have RCA inputs.  

The most important thing is what you can hear.  Some features of XLR, like higher noise rejection or locking connectors with female input side (pins recessed - not exposed) might be very important in a large studio - not so much at home.

PS: Both speaker terminals have about 30V DC (half of supply) on them - do not short  either to GND.

 

kijanki

PS Audio S300 is not fully balanced ...

You might want to check the specs of the amplifier here. They certainly reflect those of a balanced amp.

@cleeds   I don't see anything in specs showing fully balanced operation.  

Look at page 5, Fig 1  300AS1 datasheet  showing block diagram.  After balanced input, there is only one path (one amplifier).

https://shop.icepoweraudio.com/wp-content/uploads/2023/02/ICEpower300AS1_Datasheet_2_2.pdf