Wyred4Sound Dac-2 vs Preamp and separate DAC

I just hooked up my W4S DAC-2 outputs direct to my amps via balanced outputs/inputs and installed my Parasound C2 controller using the HT bypass via RCA connections. The W4S DAC-2 works well as a digital preamp and provides clear and crisp sound. The W4S remote is not all that great to use, but a larger universal remote might work better.

Previously, I had the multi-channel C2 processor doubling as stereo preamp and processor and hooked up the DAC-2 (DAC duties only) with the balanced inputs; with the C2 connecting to the amps via balanced cables.

Both ways sound very good, so I'm not sure if I'll return the Controller to preamp duties, or leave the DAC-2 to handling the digital preamp responsibilites. So far, I'd call this install a toss up.

I thought I'd follow-up on this thread as I purchased a McIntosh C48 preamp (that also has a supposedly decent DAC) and have run my Wyred4Sound DAC2 through it. I can say from a preamp perspective, if you listen to music at low volume you are better suited to not use the DAC2 as a preamp. [take the following as you may, as this is only my opinion] The DAC2 sounds "distorted" and muddy at very low volume when using it as a preamp. When you get it above 40 all that goes away. When I connected it to my C48 and set the output at fixed rather than variable, everything cleaned up nicely. So far, I can't attest to the DAC in the C48, but the preamp is nice sounding with the Wyred4Sound DAC2. (I've got other gripes about the C48, but that's not the topic of this thread).

Anyone experience similar issues with the DAC2 preamp at low volume?

50-55 too much gain?? I guess I need to play with the impedance taps on my amps as I have the opposite problem. I have some high Rez stuff that I just can't seem to get enough gain from the DAC2.

There is no resolution loss until you go way below 40 on the W4S DAC-2. If you have a problem it's not the dac but something else in your system. First, you need to match levels. My experience is that going direct to amp is far superior on every level than going through any dedicated preamp.

W4S DAC2 is not a passive preamp, but an active line stage of very high purity. Without inserting a number of switches and pots, interconnects and more active components to service all these, the clarity without an external preamp should be evident to all. The DAC2 is probably amongst one of the finest dacs one can get and the built in preamp certainly makes it a great value.

As a backup to testing, I use an Audez'e LCD-2 with Moon Silver Dragon wires to directly connect to the DAC2's phono outputs. If you have a higher resolution test setup, I'm all ears.