Equipment Set-up Recommendations?

I use a Minus K BM-1 isolation platform. This is an industrial product - isolates about 10x better than a Vibraplane (or any other air-based solution), and even outperforms 5-figure industrial active isolation solutions. In fact, the Minus K BM-1 can be used to isolate a SEM (Scanning Electron Microscope) to be used on the second floor of a building. The Minus K BM-1 is also very popular with AFM makers (Atomic Force Microscope). Bottom line: you can go with audiophile/consumer audio solutions which will be inferior while paying a 50% dealer premium, or you can go with an industrial solution which will outperform anything in the consumer audio world and really get your money's worth. Minus K has just released
a new isolator called the BM-6 which has almost the same performance as my BM-1, but at about half the price (under $2k). The new BM-8 to be released mid-Summer goes toe-to-toe with the BM-1 in a much more WAF-friendly form factor. Finally, the Minus K isolators are completely passive, so there are no facilities required for power or air - just plug and play. I'm a mechanical engineer and an audio restoration professional - I know of what I speak. I currently use the Minus K BM-1 with 75 lb granite surface plate under my Simon Yorke S7. Not only will Minus K produce audio nirvana with your turntable, but absolutely no external vibration will reach it. As proof of this, one Minus K user put their AFM on a suspended floor, and had 8 scientists jump on the floor at the same time - there was NO vibration transmitted to the AFM.

Userid, of course the Vibraplane is made by an industrial isolation company. So is the Halcyonics platform recently shown at the Stereophile show. I guess what is needed is a shootout although I never trust others ears.

I did go to the Minus K BM-1 page. THe BM-6's specifications are not the equal of the BM-1's. I don't know why these companies don't make a rack with this platform at the bottom. If it can be done, it would be more economical.

I gather that the Minus K BM-1 isolation platform is an electronic device. Long ago I recounted, for audiophiles, my experience with vibration isolation in context of using a large dish of Mercury as a reflector for optical work. Ripples on the surface of the Mercury were a big problem until we bought an electronic vibration isolator. The cost of a SOTA electronic isolator is well within the budget of high end vinyl fans.

Eldartford, the Minus K is a controlled spring device using no air pressure nor electricity.

Tbg..OK I found the website which has a good technical description. A very clever device. The picture I found earlier looked very similar to the electronic table that I used. And the price is about the same. The performance is also similar.