2. analog
  3. 1126233524

Can I install a new arm on this old table?

Folks,

I have an old Kenwood KD-500 turntable that I'm borrowing from a friend. The arm seems to be in bad shape, I'd like to replace it. Can I buy a more modern arm and plug it right in to the turntable? Would a Rega work? Is this something that a novice can do, or will I need to get into soldering etc?

Thanks!
128x128lousyreeds1
lousyreeds1's avatar
lousyreeds1 OP
286 posts
 
Thanks for the suggestion. Can you recommend a decent but cheap VTA adjuster along the lines you've specified?
brusson's avatar
brusson
9 posts
 
...the one from Pete Riggle Audio was well reviewed in "Stereophile" a while back and I think Express Machining might make one too.
lousyreeds1's avatar
lousyreeds1 OP
286 posts
 
The Pete Riggle is far more money than what I want to spend. I might just have to go with the spacers. Does anyone know where to find them?

Thanks!
afro18
51 posts
 
Reeds,

Goto www.britaudio.com and get a Incognito Easy VTA Riser. They run about $50 shipped and will allow you to adjust VTA. I got one for my Moth Alamo (P2) and still use it (although I did 'cut' it a bit smaller) on my VPI. Cheaper than spending over $100 for a Super Armboard.

Marty
More to discover