Best cable for Graham 2.2

I don't think you can make the generalization that all vacuum tables need an additional clamp,to dampen resonances.I doubt that the Walker does!

My friend,who owns my exact analog rig(Cosmos/Transfig./2.2)tried my little "cork mod",which I mailed to him.Although he confirmed a really nice improvement in sound(and promised me a nice bottle of wine),it is the Sota Reflex clamp,that seems to be the culprit(this has has stayed unchanged for about 15 years,while the tables have morphed into greater designs).This seems to be reflecting feedback,which the cart. is picking up.The clamp is actually quite resonant,and rings when struck with a finger nail( at least mine does).By placing some kind of dampening material underneath,this effect was greatly reduced,and made a really nice improvement to the sound.However it did make sense,to me,that one could re-voice the vta/downforce/fluid(combo),to a bit of a higher degree,once this slight "clamp induced signature" was reduced.I cannot say completely eliminated,as I only spent one listening session with the improved results.

Best to all,and hope all is well!

Also,Larry,hope the new super tweets are working out.I read the web-site,and according to Townsend these models apparently expose a real weekness in the Tannoy "super tweeter" designs.

The Walker does not have a vacuum platter.

Doug,sorry!You are right,and I should have thought it through a bit more,as it has air bearing and suspension,as well as air bearing arm.Basically,my thought was geared more towards tables with Clamp/weights most probably don't have the feedback issue,of the Sota clamp.I hope so,anyway.

I must make a mental note that you are a real maven (that's a compliment),in all things technical.BTW--just got my TAS,seems you'll be happy about the Triplaner review,though according to HP,all of us have to sell off our tubed equipment,now with this "fancy schmancy"battery operated solid state amp/pre,from Germany.Poor Albert Porter!!

How about the Wastch Ultima for $2400. Hand made in Utah.

There is a small company in Utah that hand makes a DIN to either RCA or XLR.
It's called Wasatch Cableworks. Their Ultima phono cable goes for around $2400. Me? I got a Graham IC-50 with the bullit RCA's and think I sounds fine. The Graham IC-70 has 2 runs of silver but cost about $200 more.($700)
If I were you I'd decide on the 2 Graham models.