Using Manley Steelhead, I am loading the XV-1s at 50 ohm and setting VTF at 2.2 ohm. HP from TAS did say that it sounded better between 2.5 and 2.7. I tried at 2.7 and did not find any significant improvements. However, the cartridge body almost bottomed out (touching the LP). So I set it back to 2.2. I do think that higher VTF sounds slightly better than lower VTF. The sound was more lifelike and vivid.
Dynavector XV-1s set up
Hi,
I've just got a new XV-1s and am trying to set it up using a Plinius M14, which I am using temporarily. The Plinius offers Cartridge Loads of 22, 47, 100, 470, 1k and 47k. The XV-1s' literature is very limited but gives a recommended load of "more than 30 ohms". Can anyone advise me on what setting will work best on the Plinius?
Also, how long will the XV-1s take to run-in? And, finally, any other set up tips and advice will be warmly welcomed.
Many thanks
- ...
- 25 posts total
- 25 posts total