phono arm to pre cables


do you think its better or not to use a phono cable like to audioquest leopard, or a standard interconnect for the arm to pre connection,
stltrains
just replaced the arm and wire on an oracle paris with an audioquest pt9 with leopard wire and it does sound more dynamic. could i have acheived the same results keeping the pt6 with generic wire and just upgrade the cartridge? probably......everything is a baby step with analologue front ends.....will upgrade cartridge next, etc. etc.....the cable is very nice.
i sure am learning the analogue dance, and loving it also, should be getting my vpi aires three very soon, with 10.5 signature arm, i am using a jps sc2 interconnect now, i have also been doing a bit of tube rolling with my ear 834, its just plan fun to find what sounds best by trial and error,
Yes, you should definitely try to use a design specific phono cable. It may be the most critical cable in your system. Depending on your budget, you might want to try the Hovland MG2, or the Cardas..... both are very good.

Chris
Dear Stltrains: No doubt that with a better phono interconnect cable you could have an improvement in the quality sound reproduction but a good cable is not inexpensive audio device.

Looking to you system and the " new " comming baby my opinion is that you will be a higher improvement in the quality sound reproduction if you go for a better phono cartridge that your Eroica.

Regards and enjoy the music.
Raul.