High mass turntable owners -- What Stand?


I'm in need of a stand to support my 100 lb. + Galibier Quattro Turntable. I would like it to have three shelves in addition to the top for the tt.

The stand will sit on a concrete floor. Other than the turntable, my other three pieces of equipment have a combined weight of approximately 30-40 lbs. Thus, the stand will be very top heavy and prone to "wobble".

With the 4" thick maple platform I use for my Galibier, I'm looking at approximately 160 lbs.

I'm not too interested in a DIY design. I have considered a Flexi Rack, I not sure it's massive enough, or laterally stable enough for my purposes.

I have been considering putting my 4" maple platform in a sandbox, so I would probably be looking at a combined weight of at least 300 pounds.

Turntable owners such as: Galibier, Teres, Verdier, Redpoint, Simon Yorke, Schu, etc. what methods of turntable support are you successfully using, and what would you recommend for my needs?
128x128mrmb
The Kuzma turntables I have here are each on SK Research shelves and three Thorp Audio Group (TAG) cones. The latter are massive stainless steel alloy cones shaped somewhat like Walker cones but have been found by others to be more effective. The SK shelves are 2" thick laminated Baltic birch plywood with some of the middle layer hollowed out and partly filled with lead and Kevlar pellets. MDF tends to suck the life out of the sound, as someone alluded to above. The Kuzma Reference with shelf and cones sit atop an SK rack, also built of Baltic birch plywood along with three TAG cones recessed into the bottom of the rack. Disclaimer: I am a dealer for the products mentioned.
I have used a Mana Reference under my Walker, Loricraft 501, and now Shindo Labs. I found a special Neuance shelf added a lot, but then found the Acapella Silencio far superior. Then I tried the Halcyonic Micro 40 active isolation base on the Mana; end of story. Expensive but clearly superior to anything I have heard.
Salectric,

Thanks for the responses. I ask, because in the near future I hope to acquire a new high-mass deck, and will need to adapt the stand I currently use which is a single shelf unit. I had my stand custom made by a welder, and it is essentially constructed of welded 2" angle iron, and follows a rough attempt at cloning a Mana type look, but of course in a much higher mass design. The stand weighs in at around 135 lbs, and sits on top of a poured fiberglass reinforced concrete basement floor. The stand was sandblasted, sanded and painted, and the "L"-shaped sections are dampened by high-density foam fill. Obviously, rapping on this stand produces no resonances whatsoever, but eventually I will need to consider something to increases its surface area, which means a shelf type thing. Since the stand was designed around my current table, and said table needs bottom subchassis access at all times, the deck and the stand have no intervening "shelf" type device. I am experimenting with 1.5" composite laboratory tabletop material, which is somewhat like Corian, but denser and flameprooof (actually it may asbestos impregnated which produces its own set of cutting difficulties). I am thinking of two layers of this material glued and pressed together with some type of elastomer type compound. No final thoughts as of yet, but I'm always curious what other people have tried, pondered or rejected. Good listening,

-Richard

Answer:
Harmonic Resolution Systems
http://www.avisolation.com/

They will custom make one for your table. $$$$$