Graham 2.2 traking force, do you use more?

Bob Graham,
What about the Nightengale II on the 2.2? Your literature shows 1.8g VTF with no range. Should one experiment with a bit more VTF, or is that the exact best setting?

Dear Audiofeil: It is only know-how and common sense!!

Regards and enjoy the music.
Raul.

Dear Zargon,
By all means, use a range of force up to 2.2 grams if necessary. The 1.8 is the "standard" setting recommended by Immutable, the manufacurer of the generator we use (we make the cartridge body and supply the 4-N silver wire ourselves)... We have found it works very well at a 2.0+ setting, and with no problems with buzzing or increased wear. As I mentioned in my post, tracking a bit (but within a reasonable range, of course) heavier is actually kinder to your records than the psychologically-tempting lighter forces which may result in poor stylus contact and groove rattling (chiseling...!)

Dear Bob Graham, I would like to ask about the damping fluid if I may.

Is it better to tune the blue damping fluid (removing fluid) to get the level of damping and hence the sound right. Usually this method leaves the damping well about half full.

Or would mixing the blue with a lower viscous fluid to give the same sound be better but allowing the entire or most of the dip stick on the 2.2 to be covered.

Would the second option give a more stable balance to the azimuth as the damping fluid is acting on the upper areas of the dip stick where there is greater movement?
would their be any detriment to the arm in the desired plane of movement ie cartridge to counterbalance?

All the best
Tris

Dear Tris,
That's one of those things that can work equally well, but some may "feel better" if they have more fluid of a lower viscosity than doing it the other way. Damping is damping, and I think the arm will not care much.
In the case of the Phantom, fluid damping is only part of it; the rest is taken care of by the magnetic stabilization system Magneglide. In this regard, there is really no reason to dilute the fluid to change damping levels, and putting in a little more (or less) standard Phantom fluid will be just fine. - Bob Graham