2. analog
  3. 1157059532

Building high-end 'tables cheap at Home Despot II

“For those who want the moon but can't afford it or those who can afford it but like to have fun and work with their hands, I'm willing to give out a recipe for a true high-end 'table which is easy to do, and fun to make as sky's the limit on design/creativity! The cost of materials, including 'table, is roughly $200 (depending, more or less), and add to that a Rega tonearm. The results are astonishing. I'll even tell/show you how to make chipboard look like marble and fool and impress all your friends. If there's interest I'll get on with this project, if not, I'll just continue making them in my basement. The next one I make will have a Corian top and have a zebra stripe pattern! Fun! Any takers?”

The Lead in “Da Thread” as posted by Johnnantais - 2-01-04

Let the saga continue. Sail on, oh ships of Lenco!
mario_b
mgreene
107 posts
 
Peter et al, It seemed to me when I saw a cut down Lenco top plate for the first time that one could fairly easily replace the Lenco top plate with aluminum sheet. I have worked 6mm Al sheet at home and making small holes on a drill press is a cinch.

The hardest thing to reproduce on the Lenco top plate would be the slot for the ider arm - you would need to carefully secure the Al sheet and use a router with a straight cutting bit and jig. The Large hole for the wheel could be cut by a jig saw and Bob's your uncle.

However, Peter if you go forward with the steel idea I am sure that some of us here (me) would like one too and would be happy to help defray the cost. Now the question - which would sound better Al or steel?

Mike
mario_b OP
147 posts
 
Hi Mike & Peter,

Gotta wonder whether the idler arm speed channel would get burred up over time with aluminum - not that I have much need to change or fine tune speeds - but I do use Peter's Post for idler wheel disengadging all the time - even to swap records.

But whatever material or design, I'm interested.

- Mario
reinderspeter
22 posts
 
My plan is to use steel because of its higher mass. the plan is for a 50x50cmm 5mm thick steel plate that will weigh aroung 8kg. It will have place for 2 arms one of which could be 12" or 9".
I plan to replace the idler adjustmentment with something simpler. You lose the disengagement possebility, but I haven't used it for while anyway and so far I cannot find any disadvantage. I know Jean said sometime ago the disengagement wasn't really neccessary.
I will try to post a picture of what I have done so far.
reinderspeter
22 posts
 
I have uploaded some pictures of topplate design in my System.
jlin
57 posts
 
Jean,

Also, do you fill it up to the brim, or just to the height of the built in screw holes for the four 4 mm bolts? Enquiring minds want to know! :-)

Jim
More to discover