Thanks Viridian, I verify that the arm is perfectly grounded to the phono preamp so I assuming what you want me to try is " ...mix one part fabric softener to two parts water and spray it on the carpet around the installation..." right?
JMW9 setup tracking problems... need help
Hi,
After almost 20 years I decided to return to analog. Looking for a good TT, found here in Audiogon a VPI Super scoutmaster with JMW9 arm in perfect condition and decide to buy it. I follow all the setup procedure: first level the turntable; then lower to arm until is parallel with the plate (to get that I had to lower the arm up to its lowest point); use an arm load meter to set up the traking force(I use a Denon 103R cartridge at 2.88g; little bit high of its higher set up of 2.8g); and rotate the counterweight to get perfect lateral balance; and finally I use the alignment jig to setup the perfect placement of the cartridge in the headshell. Everything looks OK but each time that I try to play a record the stylus runs across the vinyl and jumps half a song or more and sounds are sometimes (not always) intermitent. In inner grooves stylus track better b ut not perfect.
Maybe this is a silly question but dont know what else to try (I recheck everyhting and all looks ok) and VPI is not open until the 7th and will love to spend this holidays enjoying this grate TT. Thanks in advance
After almost 20 years I decided to return to analog. Looking for a good TT, found here in Audiogon a VPI Super scoutmaster with JMW9 arm in perfect condition and decide to buy it. I follow all the setup procedure: first level the turntable; then lower to arm until is parallel with the plate (to get that I had to lower the arm up to its lowest point); use an arm load meter to set up the traking force(I use a Denon 103R cartridge at 2.88g; little bit high of its higher set up of 2.8g); and rotate the counterweight to get perfect lateral balance; and finally I use the alignment jig to setup the perfect placement of the cartridge in the headshell. Everything looks OK but each time that I try to play a record the stylus runs across the vinyl and jumps half a song or more and sounds are sometimes (not always) intermitent. In inner grooves stylus track better b ut not perfect.
Maybe this is a silly question but dont know what else to try (I recheck everyhting and all looks ok) and VPI is not open until the 7th and will love to spend this holidays enjoying this grate TT. Thanks in advance
- ...
- 42 posts total
- 42 posts total