2. analog
  3. 1169001985

New Maplenoll Ariadne owner needing advice

I have recently purchased a maplenoll ariadne. I have tried to learn a little about the table but find very little information. I know the table was discontinued in the 90's but the little i have found indicated it is a very good table. I am interested to learn if there are any tricks or problems to optimizing this table. As most of you probably know, it is an air bearing platter and tonearm. I plan on putting my zxy airy 3 on the arm once I get it set up.
oilmanmojo
crem1
672 posts
 
Piedpiper : Thank you . I will post more details soon.
oilmanmojo OP
472 posts
 
Crem1
I took a little different approach even though it was one more piece of equipment. I hooked up a separate pump to the platter and left my large/high pressure for just my tonearm. Both systems have filters and pulsation bottles as you have described. I did this because running my larger compressor for the tonearm and platter was making my compressor run a little hot. So far very pleased with the results
piedpiper
753 posts
 
That's my plan as well. The problem is that the two of them take too much air and it's hard to get the pressure up sufficiently on the arm. Mine's running about 35 psi and I'd like to get it over 45.
oilmanmojo OP
472 posts
 
IMO, the arm performance at 45 and 50 psig is improved. I used a diaphram, oiless fish aquarium pump for platter. puts up about 5 psig and can run continously for weeks so its pretty reliable (and cheap).
piedpiper
753 posts
 
'smy experience too. What pump 'dyou get?
More to discover