New Maplenoll Ariadne owner needing advice

Oilman: LOL, The nice thing about a wife's sewing room is that the buzz of an oil less rotary vane pump is quiter than the sewing machine. :) I have a very understanding wife.

Which Junaire model did use and do you have any specs? CFM @ PSI, etc?

You are spot on with the oil smell and the need to flush that sticky mess from your air bearings and air line with isopropyl. Cleanliness is essential. I'd recommend installing new air line after flushing the bearings and making new "scuds" with PVC tubing or buy a couple of 5 gallon paint pots, or those 5 gallon air tanks without the compressor that youy can buy at O'Reillys or the Pepe Boys for $30 each.

My friend Jack bought his Signature from Mark Schneider at Music Direct. He had a plastics fabricator build him a plexiglass cover which covers the entire table, arm and all, so that his arm tube doesn't get any dust on it, while not in use. Probably not a bad idea.

Jun Air has got several models including an oil less pump. I chose the 6-15 model because of the low noise threshold (40 db), pressure 125psig (found my air really likes 40 psig) and the pressure regulation/surge tank. The volume it produces is about 37 cfm, far more than needed but this means the unit only runs maybe 30% of the time. The pressure regulation off the surge tank is very good with no noticeable drop in pressure when machine is not running. This particular model is used by i believe Pluto electronics on their airbearing table.

I have cleaned the damping tubes and replaced with new fiber and replaced air lines as part of my compressor change out. Jun Air uses a compressor oil that is odorless and does not flash over during operation to any extent. Condensed water is a bigger problem due to the humidity

good tip on the cover, i really need to get one.

good luck baranyi, keep us informed on your progress. Love to share ideas about these great tables

I also bought the highest quality regulators that I could find, with the thought that less regulator flutter would equate to less air pulsation. I discarded the PVC plastic "scuds" with air tanks, one large 15 gallon tank back where I store the air pump and the other, a new 5 gallon "airpot" just behind the turntable stand. I'd also purchased the best quality water seperators and dessicant driers at the output of each tank, too.

One warning: with 15 gallons of airtank storage, you'll need to turn on your air compressor 5 or 10 minutes before listening, but the extra storage area made an audible difference.

Oilman: 37 cfm? That thing must be the size of a car. :)

oops, 37 liters/min (1.31 cfm), its actually pretty small with the exception of the tank. I really like the large air tank, got to help the stability of the air system.

any recommended source for a round belt I believe is aprox 1/16" or 3/32" x 38"? circumference drive belt that wraps around lead platter on Ariadne to plinth pulley. Let me know if measurement is different and best source. Thanks