2. analog
  3. 1174270052

Magic Diamond vs Airtight PC1?

In my quest for a new cartridge I seem to be narrowing my choice down to a Magic Diamond vs Airtight PC1. I have not been able to hear either of these so I am looking for any insight anyone can provide. I will be using the cartridge on a VPI TNT IV with an Eminent Technology 2.4 tone arm with the high pressure manifold. I am running dual mono with two Krell KPA Phono preamps. Thank you for any input.
128x128krc
Ag insider logo xs@2x
rauliruegas
13,109 posts
 
Dear Krc: I think that you have to look too to the Allaerts MC2 Finish, great performer!!!! and at least in the same level that the other two you asked.

Regards and enjoy the music.
Raul.
krc's avatar
krc OP
16 posts
 
Thank you Raul
ejaynycrrcom's avatar
ejaynycrrcom
32 posts
 
Gents,

Thanks for the responses. One thing I noticed when setting up the MD on the Phantom is that I had to adjust the azimuth sharply to the left in order for the bottom of the cartridge to be parallel with the record. I'm not sure if this is an issue with the cartidge or the arm. Any thoughts? Thanks.

Evan
krc's avatar
krc OP
16 posts
 
Raul, are there any qualitative comparisons you can make about the allaerts vs the MD vs the PC1? Thanks.
rushton's avatar
rushton
2,445 posts
 
Ejayncrrcom, keep in mind that you are aligning the cantilever and stylus to the record groove, not the cartridge body. It is possible for any cartidge to have it's body and its cartridge assembly out of alignment with each other due to some variability in assembly; that in itself will not affect playback performance. Just focus on setting your asimuth based on the cantilever/sylus assembly relative to the record groove, and use some careful listening to optimize.
.
More to discover