2. analog
  3. 1182127050

VPI RCM 17 F trouble, very urgent NEED HELP......

I am running into problems constantly. The matt platter runs loose after cleaning 2 or 3 records at a time. I have to remove the matt platter and tighten the shaft screws. I am growign tired of this excercise. I was wondering if there is any thing that can be done to fix this issue.

I will also call up VPI and ask about this problem, and see that they have to say.
njaferi
schipo
1,268 posts
 
Are you tightning the screw by hand, maybe a tool is needed for proper tightness? I think you will get a better answer from VPI let us know.
njaferi OP
45 posts
 
I am using the L key for this.
chadnliz's avatar
chadnliz
3,737 posts
 
Can you put a locking washer on it by chance, or a locking compound?
schipo
1,268 posts
 
Something is most likely stripped if hand tightning is not working with the use of proper tool. Wait and call VPI and let them clear up the problem. I have a strange feeling they will have to look at it and make a parts replacment/send you a new part, or give you a new unit.

good luck
yioryos's avatar
yioryos
723 posts
 
Medium strength Loctite available at Home Depot.Take the screws out completely and brush the threads clean with alcohol using an old toothbrush.Then place a drop of Loctite on them and torque them back in.Done for good.Loctite is not good for plastic parts though.Note that the medium strength Loctite is removable with excessive force .There is also a permanent Loctite but I wouldn't recommend it.That's what we use at work to install bolts.
Best of luck
George
More to discover