Just to make a few thing clear here folks, The screw is not getitng loose that much. The Platter sits on a shaft that is rotated by the motor inside the VPI 17F, there are three screws that fix the platter onto the shaff, these 3 screws are on the top of the patter they just hold the platter.
Now the screws I am talking about are below this metal disk that holds the platter. The Disk has two screws and they are slipping.
I guess the information that I put upfront was not complete.
Now the screws I am talking about are below this metal disk that holds the platter. The Disk has two screws and they are slipping.
I guess the information that I put upfront was not complete.