Best MM for the money or?

FYI, it's .2mV, not .02mv.

As you may know, most MCs are in the .5-.8mV @5cm/sec. A .4mV output will gain you 6dB and a .8mV will gain you 12dB. No need to go to an MM for higher output. Of course, a step up transformer can be had for as little as $100 with some degradation. Whether that degradation is more important to you than the degradation of your wallet is the question, not to mention the question of what cartridge to upgrade to, and how much it will cost.

And by all means don't wait too long to retire the Adcom and get those VTLs back in the game.

I'm sure i can buy quiter tubes and have done that by purchasing some Mullards. VTL checked the unit out and put new tubes in just before i put it in storage free of charge in fact they upgraded the phono section for me. I think I need to go with a higher ohm cartridge.

I have been quite satisfied with the sound from my 2 B&O MM carts, 1 is an MMC2 and the other an MMC1. The MMC1 was hand-calibrated and tested at the factory. The response graph enclosed with the cartridge is the flattest I have ever seen, +- 0.1db from 20Hz - 20KHz

I won it in a sales contest back when I was selling a lot of B&O gear. They let me pick thru 30 carts to find the best one - it is phenomenal. Cost me $0 back then, they go for ~$800 now...Sounds really good on my B&O 9000 tangential tracking turntable.

-RW-

Hi Qdrone,

There are a couple of obscure moving iron cartridges from the past that will rival many moving coils, but finding one in NOS condition at this point would border on a miracle. That said, Soundsmith's new "Voice" is a moving iron cartridge that is being incredibly well received. Frank Schröder, who makes the wonderful tonearm, commented that it is the finest, or near the finest, cartridge that he has ever heard. (I don't want to misquote him, but that is the gist of his comment on another forum.) In any event, that one may be well worth the effort to seek out.

Regards,