Installation Instructions??

Dear Stringree: You can use your hand or like Bdgregory suggest a needle-nose pliers. It is better to make the wires set-up before you mount the cartridge and before that check if the wire clips could connect easy to the cartridge pins and if are a little " narrow " then use a tootpick to make " bigger " and then to the cartridge pins.
Anyway you habe to do it with care.

Regards and enjoy the music.
Raul.

Tweezers. Borrow a pair from your wife. Needle-nose pliers are too potentially damaging to use for this job, IMO. If you squeeze too tight while concentrating on mating the connector to the pin, you can narrow the opening and thereby lose all hope of making the connection. As to your other question, DEFINITELY mount the cartridge in the headshell first, before attempting to make connections. (No need to align the cartridge prior to making connections; just use the headshell as a way of stabilizing the cartridge while inserting the clips. Then you can make the fine alignment adjustments of the cartridge AFTER the wires are connected.) BTW, a good contact enhancer, like the Walker SST or whatever else you like, is very beneficial when applied between the cartridge pins and the connectors.

Lewm- What a good idea. Tweezers for sure. As for the order, I have always mounted the cart first, then connected the clips. BTW, if you want nerve-racking, try doing this with a nude canteliver cart like the benz or on a tt with no arm rest like the schroder. Luckily, I did not have both at the same time!!!

Another vote for tweezers. I usually mount the cart on the arm LOOSELY, then attach the clips, then tighten the cart screws, checking the cart alignment with your protractor of choice. before the final tightening. All. Very. Carefully.

A handy hint. Roll up some Mortite (plumber's putting) or a Blu-Tack equivalent so you have a thin cylinder -- something you can twirl between thumb and forefinger -- that's about an inch long and use it to hold the nut and/or tighten the screw before you use a screwdriver for the final tightening. Good luck, Dave

Use a hemostat (electronic/medical/fishing supply places) and clamp onto the wire crimp using the first setting(click). Sometimes it is hard to hold onto the connector and push at the same time,