Koetsu Urushi + MC step up transformer

spider, the values one uses to match a MC cart to a SUT have nothing to do with the load resistance you would use if connecting the cartridge to a phono preamp or headamp. You need to do a search on vinyl asylum or here on Agon to get pointed in the right direction. BTW, the SUT's themselves can come in two or three ranges which work best with certain cartridges. Wish I could be more help ;-)

OK here's the specifics of the set up so far:

Lundahl LL1681 MC transformers using the 13:1 tap.
With a primary resistance of 9.6 ohms and a secondary resistance of 1640 ohms, courtesy of K & K I get:

Req Load......Resistance
50..................15600
75..................24114
100................35310
125................50689
150................73135
175................108974

I've only got a couple of resistors to hand so I've only played around with parallel resistances of 18K, 47K (and 13K and 65K if you do the maths). None of them sound good.

Given the relationship of input:output load being the square of the step up ratio I can't see how I can get my Urushi to "see" the sweet 47K it used to?
.

Nsgarch, You wrote, "spider, the values one uses to match a MC cart to a SUT have nothing to do with the load resistance you would use if connecting the cartridge to a phono preamp or headamp." Are you suggesting that my advice in my previous post was completely incorrect? If so, I'd like to know, because I hate to think I've misinformed spider (or anyone else). When he bought the Lundahls (presumably from K&K), I presume that they knew how he was going to use them and that therefore the ones he's got are already a reasonable match gain-wise for the Urushi playing into the CJ.

Re your last post, the consensus among us other users of the Urushi is that you would be best off with a load of ~100ohms. If you really want 47K ohms, then just off the top of my pointy head you will need to replace the 47K resistor at the input of the CJ with a very much larger one; the value would be 169 X 47K (given your reported 13:1 turns ratio), nearly 10 Megohms! You may as well try 10M. I don't recommend it but try it if you are convinced that the cartridge performed best into 47K ohms load. You are not alone in this belief; Allen Wright, a well-respected designer and manufacturer runs all his LOMCs into 47K. You need either to remove the stock 47K load resistor entirely and replace it with 10M or to place 10M in series with the 47K one.

Lew, probably what I should have said was that it takes different value resistors (across the transformer taps) to achieve the same load conditions for the cartridge as if it was simply driving a phono preamp. So your explanation of how to load the SUT seems perfectly logical to me, but then I've never tried to do it, so I have no credibility whatsoever ;-)
.