Steelhead as a preamp?

By the way, I agree with the comments in support of the Steelhead's MM inputs. I experimented running my Dynavector XV-1s into the MC inputs (which routes the signal through the autoformers) and into the MM inputs. I found the sound through the MM inputs to be more transparent as noted above. As long as you have sufficient gain using the Steelhead's active gain stages, I too would recommend using the MM inputs over the MC inputs.

The flexibility of the MM vs. MC inputs along with all of the other features is very compelling. I was just hoping to find the best way to use the SH without having to buy a preamp. I'm going to go ahead with one and use it until I have another pre in the house. Maybe I'll find I don't need one in my setup, but I suspect I will. Thanks for all comments and in advance for any more thoughts.

Rloggie,

I did not find running the Steelhead into the amps to "soften" things. If anything I found the leading edge, transients and microdynamics much more defined - i.e., it was much more transparent. Having said that, it is less bloomy (as I said, using the moving magnet output) - at times it could sound threadbare. If I had had a really good pre-amp and put the Steelhead through that using the moving magnet output, that, as Cincy-bob points out might have been the ideal combination. But you have to spend some serious bucks to get a preamp that is good enough to let the Steelhead shine. In the end, I have gone with the Dartzeel preamp which is a great linestage and has a great phono preamp

I checked this out when I was looking for a new phono preamp.This is a very good preamp and sounds best by it self. Now it has a remote for volume control.