Lonestar, Your sentiments are commendable. The Walker Audio Proscenium is built out of lead too, but at that price, not many of them are going to end up in landfills, ever.
As far as tubes for the SP10 power supply, I quite agree that that sounds impractical. Perhaps Albert has heard the optional tube power supply available for the Brinkmann table. (That's the only tube tt ps I know of.) But that PS only has to supply sine waves to run the Brinkmann motor and to control its speed. There is no servo mechanism, etc, to worry about. It would be nice enough if any of the known ongoing projects to build modern outboard supplies for the SP10 would finally come to fruition. I refer to Mark Kelly's project and to that of "Steerpike" over on diyaudio. Either of those devices, like the Kaneta, would enable one to remove the electronics from the chassis and sink the motor directly into a plinth, thereby dramatically improving the coupling of the motor to a high mass.
As far as tubes for the SP10 power supply, I quite agree that that sounds impractical. Perhaps Albert has heard the optional tube power supply available for the Brinkmann table. (That's the only tube tt ps I know of.) But that PS only has to supply sine waves to run the Brinkmann motor and to control its speed. There is no servo mechanism, etc, to worry about. It would be nice enough if any of the known ongoing projects to build modern outboard supplies for the SP10 would finally come to fruition. I refer to Mark Kelly's project and to that of "Steerpike" over on diyaudio. Either of those devices, like the Kaneta, would enable one to remove the electronics from the chassis and sink the motor directly into a plinth, thereby dramatically improving the coupling of the motor to a high mass.