Worth upgrading tonearm cable?

And is the Rega substantially better than the Linn?

I should have specified my reasons for recommending it. The Rega is cast as one piece out of magnesium. SME also does this but no one remotely close to Rega's selling price does. This produces a much more rigid, resonance free arm. Rega can only afford this because of economies of scale as they not only produce arms for themselves but for many other turntable companies. It is safe to say that they are essentially the default choice for those who do not wish to spend over $2000 on an arm. I have used them myself at a time when I was an SME dealer. The SME was better but the Rega was not embarrassed by the comparison.

I was talking about the Rega arms at a local dealer the other day. Seems almost nobody sells arms separate from the tables anymore, but “he could get me one.” I'd also need a new Rega-cut arm mounting board for the SOTA table and, apparently, some shims for the arm, which I hear has no vertical adjustment. Another possibility would be to buy a better Linn arm, used... Then I wouldn't have to mess with a new arm board for the 'table. Thoughts?

The Rega 301 which lists for $495 is currently in Stereophile's Class A along with arms like the Linn Ekos SE which costs $4950. The next cheapest arm after the Rega is the VPI at $2400. The Linn Ittok , which I had at the same time as the Rega is as good but different. I think you will pay about $900 used for one. I have been an audio dealer most of my adult life( never for Rega) and the local dealer sounds like an idiot. You can tell him I said so. The Rega I previously recommended came with VTA adjustment. VTA adjusters for the Rega are available from many sources, including VPI, theirs is $150. What makes you sure that another Linn arm would fit in the same hole. If you don't care about appearances drill another hole in the same board.

Thanks for the advice. There's a guy on eBay selling predrilled arm boards for SOTA tables. I might go that route.