Well Tempered Reference Arm

I think from spindle to pivot 9.2 inch or (234mm)and the 20 degree tracking angle for the cartridge.

Dear Mred: I don't know how the WT arm stacks up against the others but being an audionut I had to have a new TT after 15 years and bought a Kuzma Reference TT and 4 Point arm. Haven't A-B them but I like new things and am very happy with it.

Mann,

Thanks for your response but your info differs from Donaudios'(via Wallytractor). Where did you get your info?

Rauliruegas,

Re: Stanalog..........I'm very frustrated because I've tried many times over the last 2-3 months (both phone and Email) to contact them and have gotten no response. Any ideas why??

Mred,

I also have an interest since I have a Well Tempered reference arm & table also. Note that my table goes back to the square motor design.

I also have a Wally Tractor and Wally sent me one that had an effective legnth of 235mm, same as a Graham. My spindle to pivot measures about 217mm. Note that this is a pain to measure since the pivot is where the threads intersect.

I've assumed that the effective length was the distance from the pivot to the stylus tip - thus this measurement depends on the cartridge that you'd be using. - I think! I'm using a Shelter 901.

As far as offset angle, are you referring to the angle of the cartridge mounting head? If so, I measured that angle at 68 degrees.

Hope this doesn't confuse any further. I'm going to try to remeasure again & I'll let you know what I come up with.

Steve